1988 Golden Wave Ketch/Cutter new used boats for sale dealers reviews boat classifieds

	1988	Golden Wave	Ketch/Cutter
	Ad Listing # 1215864460

Click A Photo To View Gallery

Payment Calculator

Amount:

Rate:

Years:

Payment:

Dealer Information

Company:	Edwards Yacht Sales	Contact:	Roy Edwards
Location:	Clearwater, Florida	Toll Free:	866-220-9319
Local Phone:	727-507-8222	Fax:	727-531-9379
Listings:	View Dealer Gallery

Send A Quick Email Inquiry

Email Address:
Inquiry:

Specifications

Make:	Golden Wave	Price:(US Dollars)	$164,900
Model:	Ketch/Cutter	Year:	1988
Category:	Cutter Sailer	Boat Location:	Port Charlotte, FL
Trailer:	No

Dimensions & Weight

Length:	48.00	Beam:	15' 9
Draft:	4' 6	Weight:	34000

Speed, Capacities & Hull

Cruising Speed:	7	Fuel Capacity:	6.400 lt
Maximum Speed:	8.5	Fuel Type:	Diesel
Holding:	15	Water:	150
Hull Type:	Fiberglass

Engine Details

Engine Type:	Single Diesel	Engine Year:	1988
Engine Hours:	500	Horsepower:	85

General Description

Accommodations
Working from forward to aft, the layout starts with a crews sleeping area or storage area in the forepeak. Just aft is an ensuite shower/head which leads into a cabin with a large sleeping area to port and bunks which have been converted to contained storage areas on the starboard side. Aft of this area is the salon and galley. The galley is on the port side and the large settee which converts to a beth is on the starboard side.

Aft of the settee, is the nav station. Aft of the nav station is an open area with bunk berths which is currently used for storage. Across from the nav station is a captain's quarters which has an ensuite head which is aft of the galley and a large berth running the remaining length of the port side.

The engine is located under the cockpit and the companionway stairs are between the nav station and the captain's quarters. 6 new Bowmar ss ports
6 large Lewmar hatches
New cushions and upholstery throughout

Galley
The u-shaped galley is forward of the captain's quarters. The stove, storage and sinks run down the port side. Centerline of the boat is the large refrigerator/freezer. Each compartment has it's own holding plate and the refrigerator section is front opening towards the bow. (This is nice as items won't tend to fall out when she is sailing and heeling.) Grunert 110 Vac w/2 holding plates
Force 10 3 burner stove/oven
double ss sinks
pressurized hot & cold water
12 Vdc Pur watermaker 35 GPD

Electronics
Garmin GPS 76
Raytheon R20 Radar
w/ 4kW radome
Raystar 390GPS
ICOM VHF IC-M45
Garmin GPS 128
Autohelm 6000 autopilot w/hydraulic ram
JRC 1000 Radar

Electrical
30 Amp shore power service
50' 30 amp shore power cable
3000 W Prowatt Inverter

Deck and Hull Equipment
The hull has been repainted recently with Petit EasyPoxy. The bottom was rebarrier coated and is currently painted with West Marine CPP bottom paint. The deck has had the teak removed with new teak bonded and installed along the outer border and has been painted with a non-skid in the inter areas of the foredeck.

The centerboard is controlled from the cockpit.

She has a large aft cockpit. Two seats lift up for easy access to two large lazerettes. The helm is impressive with a wheel that is so big that the cockpit has a groove in the floor to accommodate it's diameter. This large wheel adds to the ease of sailing her from either side. The wheel has a special gear to release it to reduce the work on the autopilot. Ground tackle:
12 Vdc Maxwell 850 Windlass
23 KG Bruce Anchor
100' G4 3/8" chain
100" 5/8" nylon rode
88# Delta
45# CQR
Stanchions and bases have been replaced
--------------------------------
Winches:
Main mast- Barient #24
Barient #28
Barient #25 (2)
Barient #10 (on main boom)
Cockpit- Barient #86 (2)
Barient #32 (2)
Barient #23 (2)
Barient #27
Mizzen- Barient #10 (2)

Mechanical & Engine Room
Perkins 4286 with v-drive (500 hours)
2 blade folding Max Prop

Sails and Rigging
With her racing pedigree, the rigging has both wire and rod. The backstays on the main mast can be hydraulically adjusted from the helm. The shrouds are run inboard of the deck for better sheeting angles on the jib. Harken Roller furling on jib
UK 120% Jib- good shape
UK Main- fully battened and good shape
extra main & 120% in fair shape
Older mizzen sail
Cruising spinnaker- excellent shape
3/4 spinnaker-
#1 & #3 Kevlar/Mylar jibs
Upgraded sail track on main mast